Special Tools
GE-8001 Dial Indicator Set
CH-39570 Chassis Ear
Equivalent regional tools: Special Tools
|
Step |
Action |
Values |
Yes |
No |
|
|
1 |
Did you review the Suspension General Description and perform the necessary inspections? |
— |
Go to Step 2 |
Go to Symptoms - Suspension General Diagnosis |
|
|
2 |
Road test the vehicle in order to verify the customer complaint. Does the vehicle operate normally? |
— |
System OK |
Go to Step 3 |
|
|
3 |
1. Raise and support the vehicle. Lifting and Jacking the Vehicle 2. Inspect for tire or wheel damage. Tire and Wheel Assembly Runout Measurement - On-Vehicle Did you find and correct the condition? |
— |
Go to Step 7 |
Go to Step 4 |
|
|
4 |
1. Install the CH-39570 Chassis Ear . 2. Road test the vehicle to verify the location of the wheel bearing/hub noise. Did you locate the source of the wheel bearing/hub noise? |
— |
Go to Step 6 |
Go to Step 5 |
|
|
5 |
Important: Support the vehicle by the front lower control arms or the rear axle to prevent movement during wheel bearing/hub inspection. 1. Mount and secure the GE-8001 Dial Indicator Set. 2. Ensure that the dial indicator contacts the vertical surface of the wheel as close as possible to the top wheel stud. |
0.127 mm (0.005 in) |
Go to Step 6 |
System OK |
|
| Step |
Action |
Values |
Yes |
No |
|
3. Push and pull on the top of the tire in order to inspect the total travel indicated by the dial indicator. Is the measurement greater then the specified value? |
|
|
|
| 6 |
Replace the wheel bearing/hub. Front Wheel Hub, Bearing, and Seal Replacement Rear Wheel Hub Replacement Did you complete the repair? |
— |
Go to Step 7 |
— |
| 7 |
Road test the vehicle to verify the repair. Does the vehicle operate normally? |
— |
System OK |
Go to Step 3 |