Front Seat Cushion Cover and Pad Replacement

Single Use Fasteners and Components Front Seat Cushion Heater Front Seat Vent Fan Mat

Warning

To avoid personal injury, perform a passenger presence sensor rezeroing/ learn on the passenger presence system whenever you remove or replace the seat cushion trim. Failure to do so may cause the system to malfunction.

Warning

The passenger seat cushion assembly is serviced in a kit with the airbag front passenger presence module, cushion pad (and if equipped, heat mat, vent mat, vent mat support, comfort pads). All components in the service kit are assembled and calibrated as a unit and must be replaced as a complete assembly to prevent possible injury to the occupant. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.

Caution

General Motors does not support the application of any additional adhesive to reinstall seat components. Use only the pre-applied adhesive to install the seat components. Use of additional adhesives may damage seat components, cause safety concerns, or performance issues. Removal Procedure

Front Seat Cushion Cover and Pad Replacement — figure 1

1. Front Seat Cushion Cover and Pad (1) » Remove — Front Seat Cushion Cover and Pad Removal and Installation

Front Seat Cushion Cover and Pad Replacement — figure 2

2. Remove the front seat cushion cover (1) from the front seat cushion pad (2).
3. If replacing the front seat cushion pad (2), DISCARD the front seat cushion heater and front seat vent fan mat, if equipped.
4. If equipped, transfer the front seat lane departure warning actuators. Installation Procedure

Caution

Ensure the seat heater is not folded or creased during installation as damage to the internal circuitry may occur, causing performance issues and damage to seat components.

1. If replacing the front seat cushion pad (2), install NEW front seat cushion heater and front seat vent fan mat, if equipped.

2. Install the front seat cushion cover (1) onto the front seat cushion pad (2).

3. Front Seat Cushion Cover and Pad (1) » Install — Front Seat Cushion Cover and Pad Removal and Installation

4. Perform the necessary programming and setup procedure: Control Module References