Skip to content
Tahoe / Yukon Service Manual

DTC P25C6 or P25C7

Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure: Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis: Strategy Based Diagnosis An overview of each diagnostic category can be found here: Diagnostic Procedure Instructions DTC Descriptor DTC P25C6 Control Module Temperature Sensor 1 Circuit Low Voltage DTC P25C7 Control Module Temperature Sensor 1 Circuit High Voltage Symptom Byte Information: Symptom Byte List Circuit/System Description For an overview of the component/system, refer to: Hydraulic Brake System Description and Operation Conditions for Running the DTC Ignition/Vehicle = OFF Conditions for Setting the DTC Brake Booster Control Module Temperature = Out Of Range Actions Taken When the DTC Sets None Conditions for Clearing the DTC The conditions for setting the DTC no longer exist. Reference Information Schematic Reference Hydraulic Brake Schematics Connector End View Reference Master Electrical Component List Electrical Information Reference Circuit Testing Connector Repairs Testing for Intermittent Conditions and Poor Connections Wiring Repairs Control Module References for scan tool information Circuit/System Verification

  1. Ignition » On / Vehicle » In Service Mode
  2. Verify DTC is not set: ⇒ If the DTC is set 2.1. Perform all necessary programming and setup procedures for the control module: K160  Brake System Control Module 2.2. Verify the DTC does not set. ⇒ If the DTC sets » Replace the component: K160 Brake System Control Module ⇓ If the DTC is not set 2.3. All OK. ⇓ If the DTC is not set
  3. All OK. Repair Instructions Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification For control module replacement, programming, and setup refer to: Control Module References