Skip to content
Tahoe / Yukon Service Manual

Remote Function Actuator Module Replacement

Removal Procedure

  1. Disable the SIR system. SIR Disabling and Enabling
Remote Function Actuator Module Replacement — figure 1
Remote Function Actuator Module Replacement — figure 1
  1. Rear Seat Belt Retractor Sleeve (1) » Reposition
  2. Rear Seat Belt Anchor Plate Bolt (2) » Remove
Remote Function Actuator Module Replacement — figure 2
Remote Function Actuator Module Replacement — figure 2
  1. Rear Seat Belt Opening Bezel (1) » Disengage
Remote Function Actuator Module Replacement — figure 3
Remote Function Actuator Module Replacement — figure 3
  1. Quarter Window Trim Finish Panel Bolt Cap (1) » Remove
  2. Quarter Window Trim Finish Panel Bolt (2) » Remove
Remote Function Actuator Module Replacement — figure 4
Remote Function Actuator Module Replacement — figure 4
  1. Using a flat-bladed plastic trim tool, release the retaining clips.
  1. Body Lock Pillar Upper Trim Panel (1) » Remove
Remote Function Actuator Module Replacement — figure 5
Remote Function Actuator Module Replacement — figure 5

  1. Disconnect the electrical connector.

  2. Release the retaining tab.

  3. Remote Function Actuator Module (1) » Remove Installation Procedure

  4. Remote Function Actuator Module (1) » Install

  5. Secure the retaining tab.

  6. Connect the electrical connector.

  1. Body Lock Pillar Upper Trim Panel (1) » Install

  1. Quarter Window Trim Finish Panel Bolt (2) » Install and tighten — Fastener Specifications

  2. Quarter Window Trim Finish Panel Bolt Cap (1) » Install

  3. Rear Seat Belt Opening Bezel (1) » Install

  4. Rear Seat Belt Retractor Anchor Plate Bolt (2) » Install and tighten — Fastener Specifications

  5. Rear Seat Belt Retractor Sleeve (1) » Reposition

  6. Enable the SIR System. SIR Disabling and Enabling