Skip to content
Tahoe / Yukon Service Manual

DTC C05CC or C05CF

Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure: Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis: Strategy Based Diagnosis An overview of each diagnostic category can be found here: Diagnostic Procedure Instructions DTC Descriptor DTC C05CC Brake Master Cylinder Piston Position Sensor 1 Circuit Performance DTC C05CF Brake Master Cylinder Piston Position Sensor 2 Circuit Performance Symptom Byte Information: Symptom Byte List Circuit/System Description For an overview of the component/system, refer to: ABS Description and Operation Conditions for Running the DTC Ignition/Vehicle = ON Conditions for Setting the DTC Input Rod Position 1 & Input Rod Position 2 = Greater than 38 mm (1.5 in) — Brake Pedal Applied Input Rod Position 1 or Input Rod Position 2 = Greater than 2.5 mm (0.1 in) — Brake Pedal Not Applied Input Rod Position 1 or Input Rod Position 2 = 2 mm (0.08 in) Actions Taken When the DTC Sets Malfunction Indicator Lamp = ON A message and/or warning indicator may be displayed to the driver. DTCs listed in the DTC Descriptor category = = Type A DTC Conditions for Clearing the DTC DTCs listed in the DTC Descriptor category = = Type A DTC Reference Information Schematic Reference Antilock Brake System Schematics Connector End View Reference Master Electrical Component List Electrical Information Reference Circuit Testing Connector Repairs Testing for Intermittent Conditions and Poor Connections Wiring Repairs DTC Type Reference Powertrain Diagnostic Trouble Code (DTC) Type Definitions Scan Tool Reference Control Module References Circuit/System Verification

  1. Ignition/Vehicle » Off
  2. Ignition » On / Vehicle » In Service Mode
  3. Test or inspect for the following: Brake Pedal = Binding or Sticking Refer to: Brake System Slow Release
  4. Perform the configuration/reset function: Brake Pedal Travel Sensor Learn
  5. Verify DTC C05CC, C05CF is not set. ⇒ If the DTC sets Replace the component: A104 Brake Master Cylinder ⇓ If the DTC is not set
  6. All OK. Repair Instructions Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification For control module replacement, programming, and setup refer to: Control Module References