Skip to content
Tahoe / Yukon Service Manual

Side Obstacle Detection Control Module Replacement

Removal Procedure

  1. Raise and support the vehicle.
Side Obstacle Detection Control Module Replacement — figure 1
Side Obstacle Detection Control Module Replacement — figure 1

  1. Disconnect the electrical connector.

  2. Side Object Sensing Alert Module Bolt (1) » Remove

  3. Side Object Sensing Alert Module (2) » Remove Installation Procedure

  4. Side Object Sensing Alert Module (2) » Install

  1. Side Object Sensing Alert Module Bolt (1) » Install and tighten — Fastener Specifications
  2. Connect the electrical connector.
  3. Perform the necessary programming and setup procedure: — Control Module References
  4. Lower the vehicle.