DTC C2A0A

Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure: Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis: Strategy Based Diagnosis An overview of each diagnostic category can be found here: Diagnostic Procedure Instructions DTC Descriptor DTC C2A0A Vehicle Stability Control Disabling Inhibited by Suspension Control Module Symptom Byte Information: Symptom Byte List Circuit/System Description For an overview of the component/system, refer to: ABS Description and Operation Conditions for Running the DTC Ignition/Vehicle = ON Conditions for Setting the DTC Brake System Control Module detects a suspension control module malfuntion Actions Taken When the DTC Sets Traction/Stability control cannot be turned off. Conditions for Clearing the DTC The conditions for setting the DTC no longer exist. Diagnostic Aids This code sets based on information received from the suspension control module and does not indicate an ABS issue. Reference Information Schematic Reference Antilock Brake System Schematics Connector End View Reference Master Electrical Component List Electrical Information Reference Circuit Testing Connector Repairs Testing for Intermittent Conditions and Poor Connections Wiring Repairs Scan Tool Reference Control Module References Circuit/System Verification

1. Ignition » On / Vehicle » In Service Mode
2. Verify no other DTCs are set. ⇒ If other DTCs are set Refer to: Diagnostic Trouble Code (DTC) List - Vehicle ⇓ If no other DTCs are set
3. Inspect the suspension control system. Refer to: Symptoms - Suspension General Diagnosis Repair Instructions Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification For control module replacement, programming, and setup refer to: Control Module References