General Information

Chapter 1 of the factory service manual — 85 procedures.

Procedures in this chapter

• 12 V Battery Usage
• Acronyms and Units
• Air Hose Test
• Air Pressure Test
• Air_Wind Noise
• Approximate Fluid Capacities
• Arrows and Symbols
• Body Waterleak Repair
• Component Rotational Speed Calculation
• Customer Concern Verification Sheets
• Differential Pinion Input Shaft Runout Measurement
• Door Lock and Ignition Lock Folding and Non-Folding Key Cutting
• Driveline Runout Specifications
• Driveline System Balance Adjustment
• Driveline Working Angles Adjustment
• Driveline Working Angles Measurement
• Dust Leaks
• Electronic Vibration Analyzer (EVA) Description and Operation
• Engine Order Classification
• Exterior Windnoise
• Fasteners
• Fluid and Lubricant Recommendations
• Front Side Door Lock Cylinder Coding
• GM Air Filter Life System Resetting (With Scan Tool)
• GM Air Filter Life System Resetting (Without Scan Tool)
• GM Oil Life System Resetting (With Scan Tool)
• GM Oil Life System Resetting (Without Scan Tool)
• Hub_Axle Flange and Wheel Stud Runout Inspection
• Instrument Panel Compartment Door Lock Cylinder Coding
• Interior Windnoise
• Key and Lock Cylinder Coding
• Lifting and Jacking the Vehicle
• Lock Cylinder Coding - Ignition
• Maintenance Items
• Maintenance Replacement Parts (Duramax Diesel)
• Maintenance Replacement Parts (Except Duramax Diesel)
• Maintenance Schedule
• Oscilloscope Diagnostic Kit Description and Operation
• Propeller Shaft Phasing Correction
• Propeller Shaft Phasing Inspection
• Propeller Shaft Runout Measurement
• Propeller Shaft Runout Specifications
• Reed Tachometer Description
• Registered and Non-Registered Trademarks
• RPO Code List
• Soap Suds or Bubble Test
• Spare Wheel Hoist Lock Cylinder Coding
• Special Tools and Equipment
• Special Tools
• Squeaks and Rattles
• Stationary Window Waterleak Repair
• Symptoms - Vibration Diagnosis and Correction
• Text Formats and Symbols
• Thread Inserts
• Tire and Wheel Assembly Balancing - Off Vehicle
• Tire and Wheel Assembly Balancing - On-Vehicle
• Tire and Wheel Assembly Isolation Test
• Tire and Wheel Assembly Runout Measurement - Off Vehicle
• Tire and Wheel Assembly-to-Hub_Axle Flange Match-Mounting
• Tire and Wheel Inspection
• Tire and Wheel Runout Specifications
• Tire-to-Wheel Match-Mounting (Vectoring)
• Tracing Powder or Chalk Test
• Training
• Vehicle Certification, Tire Placard, and Anti-Theft Label
• Vehicle, Engine and Transmission ID and VIN Location, Derivative and Usage
• Vehicle-to-Vehicle Diagnostic Comparison
• Vibrate Software Description and Operation
• Vibration Analysis - Driveline
• Vibration Analysis - Engine Balance
• Vibration Analysis - Engine
• Vibration Analysis - Engine_Accessory Isolation
• Vibration Analysis - Hub and_or Axle Input
• Vibration Analysis - Road Testing (CH-51450-NVH Oscilloscope)
• Vibration Analysis - Road Testing (EL-38792-A Electronic Vibration Analyzer)
• Vibration Analysis - Tire and Wheel
• Vibration Diagnosis, Starting Point, and Correction
• Vibration Diagnostic Aids - Vibration Duplicated, Appears to Be Potential Operating Characteristic
• Vibration Diagnostic Aids - Vibration Duplicated, Component Not Identified
• Vibration Diagnostic Aids - Vibration Duplicated, Difficult to Isolate_Balance Component
• Vibration Diagnostic Aids - Vibration Intermittent or Not Duplicated
• Vibration Diagnostic Aids
• Vibration Theory and Terminology
• Water Hose Test
• Waterleak Test Preparation