Do not solder repairs under any circumstances as this could result in the air reference being obstructed.
If the heated oxygen sensor pigtail wiring, connector, or terminal is damaged the entire oxygen sensor assembly
must be replaced. Do not attempt to repair the wiring, connector, or terminals. In order for the sensor to function
properly it must have a clean air reference. This clean air reference is obtained by way of the oxygen sensor signal
and heater wires. Any attempt to repair the wires, connectors or terminals could result in the obstruction of the air
reference and degrade oxygen sensor performance.
The following guidelines should be used when servicing the heated oxygen sensor:
Do not apply contact cleaner or other materials to the sensor or vehicle harness connectors. These materials
may get into the sensor, causing poor performance. Also, the sensor pigtail and harness wires must not be
damaged in such a way that the wires inside are exposed. This could provide a path for foreign materials to
enter the sensor and cause performance problems.
Neither the sensor nor vehicle lead wires should be bent sharply or kinked. Sharp bends, kinks, etc., could
block the reference air path through the lead wire.
Do not remove or defeat the oxygen sensor ground wire (where applicable). Vehicles that utilize the ground
wire sensor may rely on this ground as the only ground contact to the sensor. Removal of the ground wire
will also cause poor engine performance.
To prevent damage due to water intrusion, be sure that the peripheral seal remains intact on the vehicle
harness connector.