Skip to content
Tahoe / Yukon Service Manual

Windshield Outside Moisture_Ambient Light and Humidity Sensor Replacement

Windshield Outside Moisture/Ambient Light and Humidity Sensor Replacement Single Use Fasteners and Components Windshield Outside Moisture/Ambient Light and Humidity Sensor Removal Procedure

Windshield Outside Moisture_Ambient Light and Humidity Sensor Replacement — figure 1
Windshield Outside Moisture_Ambient Light and Humidity Sensor Replacement — figure 1
  1. Windshield Multifunction Sensor Mount Bracket Cover Insert (1) » Remove
Windshield Outside Moisture_Ambient Light and Humidity Sensor Replacement — figure 2
Windshield Outside Moisture_Ambient Light and Humidity Sensor Replacement — figure 2
  1. Windshield Multifunction Sensor Mount Bracket Cover (1) » Remove
Windshield Outside Moisture_Ambient Light and Humidity Sensor Replacement — figure 3
Windshield Outside Moisture_Ambient Light and Humidity Sensor Replacement — figure 3
  1. Inside Rearview Mirror Bolt (1) » Remove
  2. Disconnect the electrical connectors.
  3. Inside Rearview Mirror (2) » Remove
Windshield Outside Moisture_Ambient Light and Humidity Sensor Replacement — figure 4
Windshield Outside Moisture_Ambient Light and Humidity Sensor Replacement — figure 4
  1. Front View Camera (1) » Remove
  2. Disconnect the electrical connectors.
Windshield Outside Moisture_Ambient Light and Humidity Sensor Replacement — figure 5
Windshield Outside Moisture_Ambient Light and Humidity Sensor Replacement — figure 5

  1. Windshield Outside Moisture/Ambient Light and Humidity Sensor (1) » Remove and DISCARD

  2. Disconnect the electrical connector. Installation Procedure

  3. Prior to the installation of the of the windshield outside moisture/ambient light and humidity sensor, clean the windshield surface and sensor bracket with an Isopropanol Alcohol, wipe until the surfaces are thoroughly clean.

  4. Windshield Outside Moisture/Ambient Light and Humidity Sensor (1) » Install NEW

  5. Connect the electrical connector.

  6. Connect the electrical connectors.

  7. Front View Camera (1) » Install

  8. Inside Rearview Mirror (2) » Install

  1. Inside Rearview Mirror Bolt (1) » Install and tighten — Fastener Specifications

  2. Connect the electrical connectors.

  3. Windshield Multifunction Sensor Mount Bracket Cover (1) » Install

  1. Windshield Multifunction Sensor Mount Bracket Cover Insert (1) » Install